Cutek Shop - Get the advice you need. - Cutek Store

CUTEK® Extreme (18.91 liters)

John-L — Fri, 03 Jun 2022 19:36:50 +0000

CUTEK® Extreme is an oil-based wood stabilizer that penetrates deeply into wood to highlight the wood’s natural grain and beauty while providing rigorous and long-lasting protection.Applied as a clear oil, CUTEK® Extreme allows wood to naturally silver over time. By mixing in one of the CUTEK® Colourtones you can enhance and maintain the freshly oiled natural look of your wood or alter its look to meet your design vision.Cutek’s Extreme Wood Protection Oil:
- deeply penetrates wood and provides long-term water repellency
- minimizes warping, cupping (warping that causes boards to curl up at their edges), and splitting
- goes on easily and gives great coverage
- is low in VOCs (Volatile Organic Compounds that can be dangerous to your health and the environment)
- can be applied in almost any weather—providing it’s dry
- is an oil so it doesn’t have a shelf life to worry about
- has multiple colourtones from which you can choose

The post CUTEK® Extreme (18.91 liters) appeared first on Cutek Store.

Deck2wall® Spacers

John-L — Wed, 14 Jul 2021 20:02:21 +0000

IAS ACCREDITED LAB TESTED

NOTE: Check with your local building codes prior to installation

Installation Guide – Model #D2W58

Cut ledger to length and lay out deck joists on ledger.
Temporarily attach the ledger in the desired location.
Drill holes as required for fasteners. Avoid joist locations and vertical grooves in siding if applicable. Refer to Deck Ledger Fastening Table on reverse side for the correct spacing of fasteners. Consult a designer or building official if needed.
Remove ledger, center Deck2wall® Spacers over bolt holes and attach spacers to the building side of the ledger. To comply with the D2W58 fastening table, install each spacer with 3-#8 x 1 5/8” Phillips Square-Driv® or GuardDog® screws, or equal. Use only premium exterior coated or 300 series stainless steel (Grip-Rite® PrimeGuard MAX®), 1 5/8” minimum length, #8 or larger.
At the building, apply sealant in and around the bolt holes / pilot holes to prevent moisture intrusion.
Position ledger against the building. Align bolt /pilot holes and secure fasteners.

Install each Deck2wall® Spacer to ledger with 3 – #8 x 1 5/8” exterior screws (as noted above) and use spacers as a template to drill through ledger. Position ledger in the desired location and continue drilling as required into supporting structure. Apply sealant and secure fasteners.

Phillips Square-Driv®, GuardDog®, and Grip-Rite® PrimeGuard MAX® are registered trademarks of their respective companies.

For complete technical information please refer to the manufacturer’s website.

Download the Installation PDF here.

The post Deck2wall® Spacers appeared first on Cutek Store.

Outdoor Gates with Style

John-L — Thu, 20 May 2021 12:02:49 +0000

36″ wide x 68″ tall (screen only) plus frame.
Frame made from 2-inch tubing, surrounding the 36″ x 68″ screen
100% powder-coated aluminum
Rust resistant and low maintenance for long-lasting enjoyment
Don’t forget to order your posts or mounting brackets! Posts and brackets sold separately.
Return Policy per manufacturer. Call for details if applicable.

Please allow 2-4 weeks lead time for product to be fabricated and shipped.

CLICK HERE FOR INSTALLATION INSTRUCTIONS